Pin mapping
Which ESP32 and expander pins the inputs, outputs and peripherals of the boneIO ESP 8x10A gen2 use
This page is for people writing their own firmware (e.g. SUPLA, Tasmota) or a configuration from scratch. You don't need it for normal setup — the installer at boneio.eu/esp and the ready YAML files already contain these pins.
The tables are generated from the controller's public ESPHome configuration, so they match the firmware. "Inverted" means the active state is low. Ports commented out in the YAML (e.g. Modbus, 1-Wire) are not in the tables — their pins are in the comments of the source file.
Source: boneio-8x10A_gen2_switches-v0_1.yaml
| Chip | Bus | Address | YAML ID |
|---|
| PCF8574 | i2c | 0x38 | pcf_inputs |
| lm75b | i2c | 0x48 | boneIO_temp |
| Name | YAML ID | On | Pin | Inverted |
|---|
| IN_01 | in_01 | PCF8574 0x38 (pcf_inputs) | 0 (P0) | yes |
| IN_02 | in_02 | PCF8574 0x38 (pcf_inputs) | 1 (P1) | yes |
| IN_03 | in_03 | PCF8574 0x38 (pcf_inputs) | 2 (P2) | yes |
| IN_04 | in_04 | PCF8574 0x38 (pcf_inputs) | 3 (P3) | yes |
| IN_05 | in_05 | PCF8574 0x38 (pcf_inputs) | 4 (P4) | yes |
| IN_06 | in_06 | PCF8574 0x38 (pcf_inputs) | 5 (P5) | yes |
| IN_07 | in_07 | PCF8574 0x38 (pcf_inputs) | 6 (P6) | yes |
| IN_08 | in_08 | PCF8574 0x38 (pcf_inputs) | 7 (P7) | yes |
| YAML ID | Name | On | Pin | Inverted |
|---|
out_01 | OUT 01 | ESP32 | GPIO18 | — |
out_02 | OUT 02 | ESP32 | GPIO17 | — |
out_03 | OUT 03 | ESP32 | GPIO16 | — |
out_04 | OUT 04 | ESP32 | GPIO15 | — |
out_05 | OUT 05 | ESP32 | GPIO7 | — |
out_06 | OUT 06 | ESP32 | GPIO6 | — |
out_07 | OUT 07 | ESP32 | GPIO5 | — |
out_08 | OUT 08 | ESP32 | GPIO4 | — |
| Function | Name | On | Pin | Inverted |
|---|
ethernet.reset_pin | eth | ESP32 | GPIO1 | — |
ethernet.interrupt_pin | eth | ESP32 | GPIO2 | — |
switch.gpio | Buzzer | ESP32 | GPIO9 | — |
ethernet.cs_pin | eth | ESP32 | GPIO12 | — |
ethernet.clk_pin | eth | ESP32 | GPIO13 | — |
uart.tx_pin | boneio_uart | ESP32 | GPIO14 | — |
uart.rx_pin | boneio_uart | ESP32 | GPIO21 | — |
switch.gpio | CAN Bus Switch | ESP32 | GPIO35 | — |
ethernet.miso_pin | eth | ESP32 | GPIO38 | — |
ethernet.mosi_pin | eth | ESP32 | GPIO39 | — |